Optimal Cutting Conditions of Abrasive Waterjet Cutting for Ti-6Al-2Sn-2Mo Alpha-Beta Alloy Using EDAS and DFA Methods

Authors : Ugochukwu Sixtus NWANKİTİ, Sunday OKE

Pages : 233-250

Doi:10.54287/gujsa.1135609

View : 116 | Download : 8

Publication Date : 2022-09-30

Article Type : Research Paper

Abstract :Abrasive waterjet machining insert ignore into journalissuearticles values(AWJM);, a known metal cutting process in manufacturing, is likely to be improved with the selection and use of the most influential parameters in machining decision-making. This work illustrates the development of two multicriteria indicators to optimize parameters for the abrasive waterjet machining process, providing optimization information for the surface morphology problem. The evaluation based on the distance from average solution insert ignore into journalissuearticles values(EDAS); method was used as the first indicator while the desirability function analysis insert ignore into journalissuearticles values(DFA); method reflects the second indicator. The results demonstrate a huge promise of both indicators, EDAS and DFA, to develop procedures for optimizing the parameters of Ti-6Al-2Sn-4Zr-2Mo alpha-beta alloy through the abrasive waterjet machining process. For the EDAS method, experimental trial 7 provided the best results with the water jet pressure of 220 bar, traverse speed of 40mm/min, and standoff distance of 1mm. The corresponding material removal rate is 151.667mm3/min while the roughness average is 2.76mm. The DFA method also provided the same results as those of the EDAS method. The present study is evidence of optimization of the parameters of Ti-6Al-2Sn-4Zr-2Mo alpha-beta alloy using the AWJM process. This warrants an intervention to enhance productivity and the economic gains of the company.
Keywords : Abrasive Machining, Waterjet, Optimization, Metal Alloys, EDAS, DFA

ORIGINAL ARTICLE URL