Microstructure and tensile properties of AISI 410 stainless steel welded TIG method

Home Page
About
Submit A Journal
Submit A Conference
Submit Paper/Book
- Submit a Preprint
- Submit a Book
Contact

International Journal of Computational and Experimental Science Engineering
Volume:9 Issue:4
Microstructure and tensile properties of AISI 410 stainless steel welded TIG method

Microstructure and tensile properties of AISI 410 stainless steel welded TIG method

Authors : Adnan Çalik, Nazım Uçar

Pages : 394-397

View : 50 | Download : 72

Publication Date : 2023-12-31

Article Type : Research Paper

Abstract :In this study, the microstructure and tensile properties of AISI 410 stainless steel were studied. TIG welding was carried out on steels by using welding wire ER 410 (AWS A5.9) 2.8 mm in diameter. The obtained results showed that while tensile and yield strength increased, the elongation value decreased significantly. The yield strength and tensile strength were measured as 619 and 801 MPa after welding process, respectively. On the other hand, the microstructure of weld metal region had a dual phase such as martensite and ferrite.
Keywords : AISI 410 stainless steel, tensile properties, microstructure, TIG, failure

ORIGINAL ARTICLE URL

VIEW PAPER (PDF)

* There may have been changes in the journal, article,conference, book, preprint etc. informations. Therefore, it would be appropriate to follow the information on the official page of the source. The information here is shared for informational purposes. IAD is not responsible for incorrect or missing information.