Milling of Al 6060 Alloy with DLC Coated Cutting Tools

Home Page
About
Submit A Journal
Submit A Conference
Submit Paper/Book
- Submit a Preprint
- Submit a Book
Contact

International Journal of Innovative Research and Reviews
Volume:3 Issue:1
Milling of Al 6060 Alloy with DLC Coated Cutting Tools

Milling of Al 6060 Alloy with DLC Coated Cutting Tools

Authors : Mustafa AY, Ayhan ETYEMEZ

Pages : 25-29

View : 37 | Download : 8

Publication Date : 2019-07-15

Article Type : Research Paper

Abstract :In this study, the effects of rotation, feed rate, and MQL cooling system flow on surface roughness and cutting forces in milling Al 6060 alloy with DLC coated cutting tools are investigated. Taguchi method was used in the test design. Thus, time and cost are saved in the tests. The results obtained from the tests were optimized and improved. Surface roughness and performance were improved with the Taguchi method. In this study, optimal workability of Al 6060 material with DLC coated end mill was tried to be determined with grey relational analysis and surface roughness and cutting force optimization was made. Ideal values were obtained when the revolution was 3500 rpm; the feed rate was 450 mm/min. Moreover, the MQL rate was 30 l/h.
Keywords : A1 6060, Cutting, GRA, MQL, Taguchi

ORIGINAL ARTICLE URL

* There may have been changes in the journal, article,conference, book, preprint etc. informations. Therefore, it would be appropriate to follow the information on the official page of the source. The information here is shared for informational purposes. IAD is not responsible for incorrect or missing information.