Application Of Triple-Shear Model To Martensitic Transformations In Fe-Ni-C Alloys

Home Page
About
Submit A Journal
Submit A Conference
Submit Paper/Book
- Submit a Preprint
- Submit a Book
Contact

Communications Faculty of Sciences University Ankara Series A2-A3 Physical and Engineering
Volume:36
Application Of Triple-Shear Model To Martensitic Transformations In Fe-Ni-C Alloys

Application Of Triple-Shear Model To Martensitic Transformations In Fe-Ni-C Alloys

Authors : M DİKİCİ

Pages : 0-0

Doi:10.1501/commua1-2_0000000063

View : 38 | Download : 9

Publication Date : 1987-01-01

Article Type : Research Paper

Abstract :Although double-shear theories of martensite crystallography vere considered more suc- cessful than the classical theories, stili it is not possibîe to explain the complete nature of the trans- formations especially in Fe alloys with ^225}f and {259}^ habit planes. Since the double-shear theories give better results than the classical theories and more than two simple shear elements were observed by electron microscope observations in these transformations, it is concluded that the number of the simple shears used in these theories should be increased. The triple-shear model which was based on the above mentioned results was found to be in good agreement with the ob servations in some Fe alloys with ^225jf habits. The same model was also applied to the Fe-Ni-C alloys with {259jf habits and gave succesful results.
Keywords : double shear, Martensitic, Fe Ni C

ORIGINAL ARTICLE URL

* There may have been changes in the journal, article,conference, book, preprint etc. informations. Therefore, it would be appropriate to follow the information on the official page of the source. The information here is shared for informational purposes. IAD is not responsible for incorrect or missing information.