Investigation of Mechanical Properties of Ti6Al4V Alloy Foams produced by Powder Metallurgy Method

Authors : Ismail Topcu

Pages : 143-152

Doi:10.29130/dubited.1062744

View : 37 | Download : 35

Publication Date : 2024-01-26

Article Type : Research Paper

Abstract :In this study, it was aimed to production titanium alloy implants, which are widely used in the biomedical industry, as foamed materials under different mechanical alloying and sintering conditions using the powder metallurgy method Tİ6Al4V alloy is good mechanical properties, good biocompatibility properties and good corrosion resistance used as hard tissue replacements and implants. Similar mechanic properties with bone are expected from the implant to work coherently for long cycles of use and without any failure. Especially, elastic modulus of implant must be similar with bones, if not, some damages at bone surface and fallowing repeats of implant surgeries are reported. This situation has a destructive effect on health, finance, and comfort of the patient/user of the implant. In this study, powder metallurgy and space holder removal methods were used to produce porous Ti6Al4V specimens. Throughout the project study different space holder materials and binder agents were used. As weight percent, 20%, 30%, 40%, 60%, 70%, 80% porous specimens were pressed at uniaxial press machine, and sintered to the 850 ºC at argon atmosphere in furnace to reduce the oxidation to the level as low as possible. The E-Modulus values of the specimens reached the desired values with increasing porosity. It was obtained as 88 MPa in the specimen with 80% porosity, decreasing inversely proportionally, especially from the 60% porosity rate.
Keywords : Metal Köpük, Sinterleme, Toz metalurjisi, Ti6Al4V, İmplant