An Experimental Investigation of the Ultrasonic-Assisted Machining of Ti6Al4V

Home Page
About
Submit A Journal
Submit A Conference
Submit Paper/Book
- Submit a Preprint
- Submit a Book
Contact

Makina Tasarım ve İmalat Dergisi
Volume:16 Issue:1
An Experimental Investigation of the Ultrasonic-Assisted Machining of Ti6Al4V

An Experimental Investigation of the Ultrasonic-Assisted Machining of Ti6Al4V

Authors : Fatih Hayati ÇAKIR, Selim GÜRGEN, Sezen ORAK, Melih Cemal KUŞHAN, Mehmet Alper SOFUOĞLU

Pages : 7-11

View : 46 | Download : 14

Publication Date : 2019-05-16

Article Type : Research Paper

Abstract :In this study, an experimental study was performed for the ultrasonic-assisted turning of Ti-6Al-4V. The surface properties of titanium alloy machined by ultrasonic-assisted turning method were examined. Also, chip morphology was investigated. These measurements were compared with conventional turning operations performed with same cutting parameters. It was seen that ultrasonic-assisted turning affects surface properties. Average surface roughness was reduced, and less deformation was observed on the workpiece surface. Also, serrated and irregular chips were observed.
Keywords : Ultrasonic assisted turning, Ti 6Al 4V, Surface roughness, Chip morphology

ORIGINAL ARTICLE URL

* There may have been changes in the journal, article,conference, book, preprint etc. informations. Therefore, it would be appropriate to follow the information on the official page of the source. The information here is shared for informational purposes. IAD is not responsible for incorrect or missing information.