Experimental investigation of cutting forces in orthogonal cutting using rounded edge worn tool

Authors : Alper UYSAL, Erhan ALTAN

Pages : 350-362

View : 38 | Download : 8

Publication Date : 2013-09-01

Article Type : Research Paper

Abstract :Cutting tools used in machining operations have slight roundness on the cutting edge regardless of their manufacturing methods. In some cases, edge of the cutting tool is specially rounded. In this study, effects of flank wear rate, cutting edge radius, uncut chip thickness, cutting speed and rake angle on cutting force, thrust force and resultant force were experimentally investigated in orthogonal cutting operations. Cutting tools having 50 μm, 125 μm and 200 μm flank wear rates and 50 μm, 100 μm and 150 μm cutting edge radii were used in experiments carried out by using quick-stop orthogonal cutting device. Experiments were carried out at three different uncut chip thicknesses insert ignore into journalissuearticles values(100 μm, 150 μm and 200 μm); and cutting speeds insert ignore into journalissuearticles values(0,25 m/dak, 0,5 m/dak and 0,75 m/dak); and two different rake angles insert ignore into journalissuearticles values(2° and 6°); and effects of flank wear rate, cutting edge radius and cutting parameters on cutting forces were determined. Cutting forces increased when flank wear rate, cutting edge radius and uncut chip thickness increased and slightly decreased when cutting speed and rake angle increased. Besides, micro views of the samples obtained from quick-stop device were analyzed and the effects of flank wear rate on dead metal zone formed in front of the tool were investigated. It was seen that dead metal zone became smaller when flank wear rate increased.
Keywords : Rounded edge worn tool, cutting forces, dead metal zone

ORIGINAL ARTICLE URL