Tool Wear in GGG50 Cast Iron Milling Environments

Home Page
About
Submit A Journal
Submit A Conference
Submit Paper/Book
- Submit a Preprint
- Submit a Book
Contact

Düzce Üniversitesi Bilim ve Teknoloji Dergisi
Volume:12 Issue:3
Tool Wear in GGG50 Cast Iron Milling Environments

Tool Wear in GGG50 Cast Iron Milling Environments

Authors : Abdulkadir Orak, Ali Kalyon

Pages : 1506-1517

Doi:10.29130/dubited.1353261

View : 78 | Download : 46

Publication Date : 2024-07-31

Article Type : Research Paper

Abstract :In the present study, the impression of manufacturing parameters on cutting tool tip wear in the milling operation of GGG50 cast iron material with carbide coated cutting tool inserts was investigated. Taguchi orthogonal L18 experimental sequence was applied as the experimental design. As processing parameters; cutting speed, coolant and feed rate were chosen. In the test results, the amount of wear on the cutting tool tips was examined. Optimum processing multiparameters were determined by the Taguchi. Analysis of variance (ANOVA) was used to analyses the effect of input parameters on the cutting tool tip. Consequently, it has been determined that the wear is high in the working environment where the coolant is open and the cutting speed is high. In order to keep the cutting tool tip wear at a minimum level, the most suitable machining parameters are; coolant = closed, cutting speed = 160 mm/min, feed rate = 0.3 mm/rev. It was determined that the tip feed rate had little impression on tool wear.
Keywords : Frezeleme, dökme demir, takım aşınması, optimizasyon, Taguchi, ANOVA

ORIGINAL ARTICLE URL

* There may have been changes in the journal, article,conference, book, preprint etc. informations. Therefore, it would be appropriate to follow the information on the official page of the source. The information here is shared for informational purposes. IAD is not responsible for incorrect or missing information.