Determination of the Tool Wear using Cutting Force in Face Milling of Ti-6Al-4V under High Pressurized Cooling Conditions

Authors : Inayet Burcu Toprak, Oğuz Çolak, Mustafa Bayhan

Pages : 82-93

Doi:10.31202/ecjse.1350095

View : 62 | Download : 87

Publication Date : 2024-03-13

Article Type : Research Paper

Abstract :In this study, plain and profile cutting operations were carried out in Ti-6Al-4V material with sharp and worn tools. In the experiments, the cutting speed was 90 [m/min], the feed rate was 0.1 [mm/tooth], and the pressure of the applied coolant was changed to 6, 100, 200, 300 bar, respectively. Haar wavelet was applied to the Fx force signals recorded during the experiments and decomposition was made at Level 5. As a result of the analysis of the obtained CA5 wavelet coefficients with the receiver operating characteristic (ROC) curve analysis, the limit values were determined to separate the worn tool from the unworn tool. In this way, it will be possible to stop the machine at the desired wear value.
Keywords : Ti 6Al 4V, Tool Wear, Cutting Force, Wavelet, ROC Analysis